The Digital Flood Insurance Rate Map (DFIRM) Database depicts flood risk information and supporting data used to develop the risk data. The primary risk classifications used are the 1-percent-annual-chance flood event, the 0.2-percent-annual-chance flood event, and areas of minimal flood risk. The DFIRM Database is derived from Flood Insurance Studies (FISs), previously published Flood Insurance Rate Maps (FIRMs), flood hazard analyses performed in support of the FISs and FIRMs, and new mapping data, where available. The FISs and FIRMs are published by the Federal Emergency Management Agency (FEMA). The file is georeferenced to earth's surface using the State Plane projection and coordinate system. The specifications for the horizontal control of DFIRM data files are consistent with those required for mapping at a scale of 1:12000.
The FIRM is the basis for floodplain management, mitigation, and insurance activities for the National Flood Insurance Program (NFIP). Insurance applications include enforcement of the mandatory purchase requirement of the Flood Disaster Protection Act, which "... requires the purchase of flood insurance by property owners who are being assisted by Federal programs or by Federally supervised, regulated or insured agencies or institutions in the acquisition or improvement of land facilities located or to be located in identified areas having special flood hazards," Section 2 (b) (4) of the Flood Disaster Protection Act of 1973. In addition to the identification of Special Flood Hazard Areas (SFHAs), the risk zones shown on the FIRMs are the basis for the establishment of premium rates for flood coverage offered through the NFIP. The DFIRM Database presents the flood risk information depicted on the FIRM in a digital format suitable for use in electronic mapping applications. The DFIRM database is a subset of the Digital FIS database that serves to archive the information collected during the FIS.
FIRM and FIS Effective Date
The hardcopy FIRM and DFIRM and the accompanying FISs are the official designation of SFHAs and Base Flood Elevations (BFEs) for the NFIP. For the purposes of the NFIP, changes to the flood risk information published by FEMA may only be performed by FEMA and through the mechanisms established in the NFIP regulations (44 CFR Parts 59-78). These digital data are produced in conjunction with the hardcopy FIRMs and generally match the hardcopy map exactly. However the hardcopy flood maps and flood profiles are the authoritative documents for the NFIP. Acknowledgement of FEMA would be appreciated in products derived from these data.
500 C Street, S.W.
The DFIRM Database consists of countywide vector files and associated attributes produced in conjunction with the hard copy FEMA FIRM. The published effective FIRM and DFIRM maps are issued as the official designation of the SFHAs. As such they are adopted by local communities and form the basis for administration of the NFIP. For these purposes they are authoritative. Provisions exist in the regulations for public review, appeals and corrections of the flood risk information shown to better match real world conditions. As with any engineering analysis of this type, variation from the estimated flood heights and floodplain boundaries is possible. Details of FEMA's requirements for the FISs and flood mapping process that produces these data are available in the Guidelines and Specifications for Flood Hazard Mapping Partners. Attribute accuracy was tested by manual comparison of source graphics with hardcopy plots and a symbolized display on an interactive computer graphic System. Independent quality control testing of FEMA's DFIRM database was also performed. To obtain more detailed information in areas where Base Flood Elevations (BFEs) and/or floodways have been determined, users are encouraged to consult the Flood Profiles and Floodway Data and/or Summary of Stillwater Elevations tables contained within the FIS report that accompanies this DFIRM database. Users should be aware that BFEs shown in the S_BFE table represent rounded whole-foot elevations. These BFEs are intended for flood insurance rating purposes only and should not be used as the sole source of flood elevation information. Accordingly, flood elevation data presented in the FIS report must be used in conjunction with the FIRM for purposes of construction and/or floodplain management. The 1-percent-annual-chance water-surface elevations shown in the S_XS table match the regulatory elevations shown in the FIS report.
When FEMA revises an FIS, adjacent studies are checked to ensure agreement between flood elevations at the boundaries. Likewise flood elevations at the confluence of streams studied independently are checked to ensure agreement at the confluence. The FIRM and the FIS are developed together and care is taken to ensure that the elevations and other features shown on the flood profiles in the FIS agree with the information shown on the FIRM. However, the elevations as shown on the FIRM are rounded whole-foot elevations. They must be shown so that a profile recreated from the elevations on the FIRM will match the FIS profiles within one half of one foot.
Data contained in the DFIRM Database files reflect the content of the source materials. Features may have been eliminated or generalized on the source graphic, due to scale and legibility constraints. With new mapping, FEMA plans to maintain full detail in the spatial data it produces. However, older information is often transferred from existing maps where some generalization has taken place. Flood risk data are developed for communities participating in the NFIP for use in insurance rating and for floodplain management. Flood hazard areas are determined using statistical analyses of records of river flow, storm tides, and rainfall; information obtained through consultation with the communities; floodplain topographic surveys; and hydrological and hydraulic analysis. Both detailed and approximate analyses are employed. Generally, detailed analyses are used to generate flood risk data only for developed or developing areas of communities. For areas where little or no development is expected to occur, FEMA uses approximate analyses to generate flood risk data. Typically, only drainage areas that are greater than one square mile are studied.
The DFIRM Database consists of countywide vector files and associated attributes produced in conjunction with the hardcopy FEMA FIRM. The published effective FIRM and DFIRM are issued as the official designation of the SFHAs. As such they are adopted by local communities and form the basis for administration of the NFIP. For these purposes they are authoritative. Provisions exist in the regulations for public review, appeals and corrections of the flood risk information shown to better match real world conditions. As with any engineering analysis of this type, variation from the estimated flood heights and floodplain boundaries is possible. Details of FEMA's requirements for the FISs and flood mapping process that produces these data are available in the Guidelines and Specifications for Flood Hazard Mapping Partners. Horizontal accuracy was tested by manual comparison of source graphics with hardcopy plots and a symbolized display on an interactive computer graphic system. Independent quality control testing of FEMA's DFIRM database was also performed.
The DFIRM Database consists of countywide vector files and associated attributes produced in conjunction with the hardcopy FEMA FIRM. The published effective FIRM and DFIRM maps are issued as the official designation of the SFHAs. As such they are adopted by local communities and form the basis for administration of the NFIP. For these purposes they are authoritative. Provisions exist in the regulations for public review, appeals and corrections of the flood risk information shown to better match real world conditions. As with any engineering analysis of this type, variation from the estimated flood heights and floodplain boundaries is possible. Details of FEMA's requirements for the FISs and flood mapping process that produces these data are available in the Guidelines and Specifications for Flood Hazard Mapping Partners. Vertical accuracy was tested by manual comparison of source graphics with hardcopy plots and a symbolized display on an interactive computer graphic system. Independent quality control testing of FEMA's DFIRM database was also performed.
Spatial and attribute information for locations of Flood Hazard lines and also Transportation features.
Spatial and attribute information for town political boundaries based upon USGS 7.5 minute quadrangle maps.
Spatial and attribute information for all land owned and operated by Connecticut DEP to gain a better understanding of the open space in the state.
Spatial and attribute information for Coastal Barrier Resources System.
Spatial and attribute information for transportation features.
Spatial and attribute information for the index of USGS 7.5-Minute Series Topographic Map boundaries.
Spatial and attribute information for Federal Properties.
Spatial information for Middlesex County Mapping.
Spatial and attribute information for locations of Flood Hazard lines and also Transportation features.
Spatial and attribute information for locations of Flood Hazard lines and also Transportation features.
Spatial and attribute information for area around city of Middletown.
Spatial information for location of a stream in the City of Middletown.
Spatial and attribute information for Digitizing of Connecticut River.
Spatial and attribute information for water areas in Connecticut.
Names and locations for low resolution streams outside of study areas.
Spatial and attribute information for Portland Connecticut.
Spatial and attribute information for Flood Hazard Lines and area, Floodways, Cross Section locations, and Structures.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, and Structures.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, and Structures.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, and Structures.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, and Structures.
Attribute information for Flood Hazard Areas.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, and Structures.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, and Structures.
Spatial and attribute information for floodplain widths, Cross section and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for floodplain widths, Cross Sections and floodplain location.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, Structures, and BFEs.
Spatial and attribute information for Flood Hazard Lines and area, and Cross Sections.
Spatial and attribute information for Used to estimate flood flows for the Connecticut River.
The DFIRM Database is compiled in conjunction with the hardcopy FIRM and the final FIS report. The specifics of the hydrologic and hydraulic analyses performed are detailed in the FIS report. The results of these studies are submitted in digital format to FEMA. These data and unrevised data from effective FIRMs are compiled onto the base map used for DFIRM publication and checked for accuracy and compliance with FEMA standards.
The DFIRM Database is made up of several data themes containing both spatial and attribute information. These data together represent the current flood risk for the subject area as identified by FEMA. The attribute tables include SFHA locations, flood zone designations, BFEs, political entities, cross-section locations, FIRM panel information, and other data related to the NFIP.
Appendix L of FEMA's Guidelines and Specifications for FEMA Flood Hazard Mapping Partners contains a detailed description of each attribute code and a reference to other relevant information. The following tables are included in this data set: L_Comm_Info L_MT1_LOMC L_Stn_Start S_BFE S_CBRS S_FIRM_Pan S_Fld_Haz_Ar S_Fld_Haz_Ln S_Gen_Struct S_Perm_Bmk S_Pol_Ar S_Pol_Ln S_Quad_Index S_Wtr_Ln S_XS Study_Info
P.O. Box 1038
Data requests must include the full name of the community or county and the FIRM panel number(s) or the 7.5- minute series quadrangle sheet area(s) covered by the request.
No warranty expressed or implied is made by FEMA regarding the utility of the data on any other system nor shall the act of distribution constitute any such warranty. FEMA will warrant the delivery of this product in a computer-readable format, and will offer appropriate adjustment of credit when the product is determined unreadable by correctly adjusted computer input peripherals, or when the physical medium is delivered in damaged condition. Requests for adjustment of credit must be made within 90 days from the date of this shipment from the ordering site.
500 C Street, S.W.
None